Phase
[An in depth view of phasing on Light Rods]
Cutting of a Light rod on a node causes the nuclear vibration side to
become amplified, and the Electron vibration side always cancels, or
goes to "still point" sensation. This is the only way to "raise a
field."
Look close at the node points above, you always cut where the Electron
shell is crossing zero. A reflection here will place the electron
side into a canceling mode 180 degrees out of phase, no matter if you
cut on an even or odd segment count.
Cutting on odd segment counts has proven to be interesting, in that
there is now an imbalance in how many nuclear polarity swings there are
pulling each direction. Cutting short on odd nodes causes the nuclear
side to pull more one direction then the other on space.
Looking close at the Nuclear Light Nodes line you see that these are
special in that they are always "peaking" in vibration on the ends of the rods, and on the segments "boundaries." The nuclear vibration side is peaking to max on all the Electron shell still points.
This creates a special situation for phasing and phase canceling.
Cutting Light rods does not cancel the "nuclear mass vibration", it
cancels the "Electron shell vibration" and reinforces the nuclear
vibrations.
To cancel the nuclear mass vibration we need to first generate a field
with one length and then with a second one channel energy into it such
that Electron shell becomes amplified and nuclear vibration is
canceled. This is the exact opposite that Light Rods accomplish.
Slim Spurling runs two rods out of phase to accomplish this. If you cut
an odd number of segments on two rods and then reverse one rod the
energy will now cancel outside and between the two rods. However we
discover the EM side is still canceled with this method also. If we
desire to bring up the EM side as we cancel the nuclear side we need a
different method.
Maximum vibration on the Electron
shell level might be achieved if we can cancel the nuclear vibrations
inside, using reflection alone, and also reflect the electron side in
phase so as to amplify EM type outer world interactions.
These two forces are countering at all times, however time is the issue
as they are not in phase but pass vibrational energy back and forth
inwards then outwards.
What would happen if we could cause a reflection at the 1/2 segment
distance without loosing the resonance of the Light Rod? The nuclear
side would now cancel and the electron shell resonance would become
additive.
I believe we may be able to accomplish this using a disc and a
tube, or inside a Joe Cell by changing our gap distance to fractal
length. Cut a tuned tube to resonate itself up using an odd segment
length. The tube will now become polarized. We set the tube against a
flat Aluminum disc that has diameter cut off at 1/2 segment length on
its outer edge distance from tube. A standing voltage node should
appear here, with a nuclear still point.
Outer rim or disc should become electric and now feed back into the entire system raising the voltage at every point.
Examine the above wave form again and notice there are places where
both waves are moving together, and other places where they are
opposing. This changes every 1/2 rod segment. One is rising where the
other is dropping and both are on the same polarity side of the zero
line.
Nuclear energy couples to
Electron shell. Cross coupling is thus possible. One tube nuclear
vibration will link to the seconds tubes Electron vibration and also
the reverse.
If we set up two tubes, we can expect a cross sum and difference. Inside to outside and outside to inside.
Levitation Site Index