Palming Techniques - Rods
A revisiting of the techniques to locate fractal rod lengths. The
process should not be done in haste. It is more important for one to be
able to sense this then to merely duplicate others lengths. The
experience will bring inner changes. There are two basic sensations to
differentiate. The first one usually noticed is "pressure" sensation at 3rd eye. The second is "Radiant Light"
and with opening to this one comes a nurturing and loving connection. I
associate the second with the reversed spin off the ends of the iron
rods and also the Kundalini energy called the serpent power, or
the caduceus coil.
In May of 2008 I was able to cut a full Light rod length, at 44.5"
and work directly with it having no headaches during the process.
Aparently I now naturally pull female energy off the rod enough to
handle the energy flows. As this contains a rather strong Kundalini or
reversed spin state, I recognize I am changing and have opened a great
deal since the first experience.
The following lengths are added to my growing list of lengths to be explored.
Sensitivity is established by opening palm energy area and first consciously projecting into the Rods.
As the energy points jump out of the rod now the fingers zero in, and finally small wires are used for accuracy.
Crossing our Light with the
Rods Light nodes causes a diversion of the amplified energy into us.
New lengths can be fully explored before actually cutting them. It will
be very surprising how both sides located using energy sensing will
have the exact same distance from center. I call this effect a Torsion Dipole. As both ends vibrate there is a perfect balance formed in the energy field between them.
A Golden Light length is set between two [Aluminum Plexiglass Aluminum]
layered plates to experience exactly what layering has to offer. Ends
are slowly moved until a strong field is sensed between.
If one does not have the patients to find exact spacing of plates then coils can be used to tune them.
The plates now become a Radiant Light transmission system. Back plate
and front plates nodes all come into allignment or phased for the
frequency used.
In the front is a set of GL rods for experiencing tunning them to
alignments which are not phased, or intentionally set out of phase to
create torsion fields of pressure.
While the rods normally produce mostly the Radiant Light if aligned
perfectly. Using two identical coils to tune the plates will allow the
EM not be shorted if layering is to be used in platonic forms where
voltage is expected to appear. These radiant light coils are a one wire electric field generator.
Two lengths were offered 150 mm and 151 mm, these are very close to 6"
and a 6" rod was found to be quite active. To the right 6" Iron tie
wires were also found to be quite powerful, also when bent into a
circle these are very close to a two inch outside diameter.
Wilbert Smith suggested it may
take 10 years to learn to work with his Conscious linking or Tensor
beam coils. The next 10 years will pass whether we open this door or
not.
On the table sets a full 6x of the 15 3/16" Golden Light Fractal, of
Aluminum at 1" diameter. Approx 7 feet 7 inches. With the AG metals we
find the reversed spin along the entire sides of the tube. Being near
this one is an all encompassing field that envelopes you. Using
Aluminum in circles would now bury the end sections and the entire form
will be Radiant as reversed spin. It is likely that a craft covered
this way would become a radiation point of raw Kundalini energy, fully
active with the operators mind.
Dave L
c_s_s_p group 5 / 04 / 2008
Back To Light Technology
Home