Precession and the Isotope line
From the study of NMR technology one gets a feel for the nucleus
of the atom existing as a free floating magnet, spinning its' ends like
it was a bar magnet moving through a dual cone system. This motion is
known as precession. With the AG metals Copper, Aluminum, and Bismuth
the Electron shell is neutral and the nucleus of the atom is free to be
manipulated using external magnetic fields.
As we bring a strong magnet, say a 1 Tesla Neo near the edge of the AG
metal the nucleus's in the copper all align with the field. You can
think of them as wanting to link together on the ends and move in
opposite angles of about 45 degrees as they precess, chained together
only at the ends. The small magnets are not strong or close enough to
create a coherent magnetic field and each one continues to have
separate poles and a separate blotch wall. They cannot become coherent
with the external magnetic field from the Electron generated magnet
because the spin is opposite with respect to the poles. These little
magnets continue to remain separate bundles of energy self contained,
and transferring energy independently. This is called the isotope line.
Cold energy configuration
As we now start to tilt a magnetic field along a smooth thin surface of
Copper or Aluminum atoms, the magnetic field manipulates their small
independent precession angles such that they align with it. A greater
number of the atoms now find themselves in the above alignment then in
the first one shown.
In this alignment you will notice that they now spin past one another
on opposite edges of their magnetic motions such that their
motional vectors oppose.
This tempic vector alignment is recognized from the time vector model
of magnetism and should tend to produce a higher density or expanding
field in at least one plane of motion speeding the time flow rate.
In the above model given, opposing magnets are added to the model to
present two external magnetic fields also in opposition to one another.
With this system added to our AG metal, as the magnets are compressed
both fields interact. Copper atoms can align two directions to one
another and as the energy state of the nucleus moves higher more of the
coppers nuclear magnetic fields will also oppose, however they will
still precess against one another.
We end up with all three tempic vectors in opposition in the AG metal
that is shooting off and up at 45 degrees in a high number of the atoms
present.
A cold energy collects near the end of the extension piece which is colder further from the magnets.
Note that it is not the interacting
large magnets in opposition that generate the tempic and diamagnetic
effects. It is only after they interact in the AG metal that we see
these effects popping up.
Experiments at c_s_s_p group showed this model to be fairly accurate, as a device using large ferrite ring magnets demonstrated.
We have already seen how once an alternate density field is created it
can propagate seemingly without loss through the AG metals.
Diamagnetic field interaction
The diamagnetic field sits normally at about 90 degrees to the Protons
magnetic field, however propagation is through the 45 degree vector of
the precession line in the AG metals. Emitting from the Neutron it is
also spinning somewhere between 90 degrees to the Protons spin plane
and some angular balance point stabilizing all the atomic shells. It's
angle is not fixed but regulates the atoms equilibrium.
Any time we set Protons against one another with respect to torsion we alter the tempic field and effect the time flow rate.
The ~ 45 degree isotope line creates two observed interactions that freely propagate. The first has been mentioned already the tempic effects which spread out at greater distance. The second is the diamagnetic field,
which because of the torsion forces, pops out of the material and
propagates along with the tempic field in an expanded mode down
the AG metal. This is a conscious field mostly, although at its source it is a raw force that repels both ends of the magnetic forces present inside the atoms.
We see the conscious field
coming up in too many devices now for it to be ignored. Hamels cones,
Otis Carrs saucer, and a host of others as well. It would appear to be
a necessary element. We are seeing many other reports now as well of
the cold energy popping up as well as the conscious link in the
RainMaker 1 unit as others come on line with new units and continue to
experiment.
Neutron and density
The heart of the diamagnetic field, the pathway to a conscious link, is the neutral center of our local system, the neutron.
While it appears to be neutral to us in science, it is a very long
distance from the center or Source of the universe in magnitude. With
its center point lies the light speed variable, not a constant, that
creates a possibility of density shifting. The nucleus of the atom is
lighter then the sum of its parts removed, which can be easily verified
by studying an atomic chart of the elements. The nucleus of the atom is
already effecting a gravity shift from this perspective and thus
creates a second Aether realm where light speed was measured already by
Tesla to be higher then our normal Electron oriented space. Energies
moving between nuclear bodies may bypass the normal EM routes taken by
electronics generated vibrations as the medium is different.
Protonics
David Lowrance
1 - 16 - 07 Kosol_Core_Tech group
Back to Theory
Home