Torsion Bonding
[Document public Kosol_Core_tech]
A closer examination of atoms and the Spinning Cylinder Experiment will
show us all the paths of torsion outwards in the atom. As torsion
couples from a Proton magnetic field to an Electron magnetic field, in
the experiments with spinning cylinders, it does not couple between
Electron shells in iron or between two copper cylinders in the same
magnetic field. The atom must work the same.
In an atom all the normal electrons are bonded to the protons by a
magnetic link and they are all paired. In the free Protons of copper we
have one free to interact with us and show us how this works. As well
we have a free Electron in the Electron shell in iron atoms to
experiment with.
It should become apparent that all paired Electron Proton bonds also
flow Torsion, although all these fields pretty much cancel near the
surface, so how does torsion really flow between atoms. Torsion moves
outwards in all the atoms magnetic links hopping from Proton to
Electron to Proton to Electron etc... To get between atoms it must use
the Electron shell as well as the Proton shell. This brings us to the
molecule and the chemical links.
I has been observed that when we break up elements to the very small
sized they often lift into the air as though weightless and are carried
by the wind, even lead atoms and copper atoms if broken down small
enough will vanish in the wind. Water seems to violate the laws of
gravity in clouds as well.
We end up with a massive weaving between matter in all directions for
all fields that appear at the atoms shells in the materials that are
bonded at the Electron layer into compounds, we end up with a permanent
link for torsion to flow between atoms. The Torsion field expands and
begins to connect with outside influences. Proton to shared
Electron to Proton. This obstacle would seem almost impossible to
overcome without breaking the bonds. The crystalline structures offer a
possible link because they are all bonded along common lines, and thus
pure crystals or crystalline metals will offer a structure to make the
forces fall into atomic coherence if correctly aligned. The correct
platonic forms lined up with the crystal bonds may offer a solution by
introducing reversed torsion fields at the correct alignments.
The diamagnetic field is setting just below the Electron shell and it
is holding all the Electrons in their orbits such that none are pulled
into the nucleus. We have identified this with the neutron and its
force function in matter to repel both ends of any magnetic
field outwards. Proton is bonded to Neutron torsionally , as
time flow rate is different at the neutron it is pushed away
tempically, and the diamagnetic field pushes both Electrons and Protons
outwards, while the Protons pull the Electrons inwards through the
electric field. Diamagnetic field is pushing on both shells so it is
present. A fine balance!
From the above logical flow it may become apparent that to decouple the
torsion bonds in matter would be far easier if we had atoms that were
not chemically bonded into solid matter, say in a diamagnetic liquid. The key lies in the
diamagnetic field and setting up conditions to increase its reach such
that it cuts off the flow between atoms. To do this it must expand outwards of the Electrons shell enough to
reduce the torsion bonding between the atoms along its entire surface
by canceling the magnetic field present there to such a level that
torsion disconnects between molecules. This takes us to the simplest
form of anti gravity device, a diamagnetic liquid based core.
While in a Copper device the diamagnetic field must interrupt the links
constantly as they will immediately recouple over time, it must also be
much stronger then if there were no chemical bonds. Copper atoms
form into rhombic structures sharing a few Electrons with other bonding
metals and the atoms or molecules are not free to spin at the Electron
layer.
The simplest molecule and most abundant is water. It is already
violating gravity effects in the clouds. Now with a greater awareness
of Torsion bonding and a better feel for how to control things from the
conscious side, we are ready to discover the true method. Once a fluid
diamagnetic material is released from the local Torsion coupled field
it can now be manipulated to shift density using reversed spin coupling
within a self contained torsion field and a conscious connection. The
alternate torsion should propagate Aluminum or Copper due to previous
experiments to spread this field into a craft uniformly.
Torsion bonding in the Neutron
We look closely at the Neutron, it is a Proton with an Electron
overlaped. As we interact it creates fields that regulate the atoms
structure.
Since the Proton sets inside the Electron, we can now see how torsion
is propagated inside the neutron. Proton - Electron - Proton moving out.
Torsion cannot move directly from the Neutron to the Electrons,
only a reverse like magnetic field can, it must pass through the Proton
layer. However this means that a Proton field interacting with a
diamagnetic field will provide Torsion, but an Electron field interacting with the diamagnetic field will not.
This is key to why releasing the torsion coupling between atoms will
not destroy the atoms. Torsion is always present at the Proton layer
and its electric field will hold the Electron shell on as electric
field is a distance squared force. Even as the magnetic field is
overpowered by the diamagnetic field the atoms will remain together.
This also indicates that operating in a diamagnetic field enviornment, Copper becomes the new element that is interactive and magnets become only a repelling force.
Dave L
Home Back to Theory
Back to Builders Group Index